To install the Cover lifter brackets on the Cambridge Spa, the vertical strips near the edge of the panel would need to be cut to allow the bracket to be properly screwed into the panel.
- Each strip is about 28" long. Remove the strip from the panel where the lifter will be installed on and cut just above the top screw hole (roughly 4.5" down). This should be enough to fit the top-mount cover lifter bracket.
- Once the strip has been cut, it will look as shown below compared to the original length.
- Proceed to re-attach the cut strip into the cabinet panel.
- Screw the bracket into the panel and complete the installation of the cover lifter following the instructions provided on the Manual.
